Ask Experts Questions for FREE Help !
Ask
    Thumbsticks's Avatar
    Thumbsticks Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 21, 2012, 02:10 PM
    How to install a shower drain
    I have a brass drain, rubber ring inner coupler compression ring, a fiber washer and a large rubber washer. Question, do I use plumbers puddy beneath the drain flange and the fiberglass shower and use the rubber ring on the bottom of the shower fiberglass with the fiber washer on top of the rubber, then the large lock nut?? Thank you very much in advance.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Aug 21, 2012, 03:10 PM
    Fiber washer goes between rubber seal and nut.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #3

    Aug 22, 2012, 07:11 AM
    Will this help? (see image)
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to install a shower drain? [ 2 Answers ]

Hi, I've torn out the old ***** floor that was over concrete. A pan or liner was never installed at construction time. My home was built in 1967. The 2" drain pipe is only 3/4" above the concrete floor. I feel I need a pitch foor to install a liner over. However, the heigth of the drain won't allow...

How do I extend a 2 inch PVC shower drain to install new shower? [ 1 Answers ]

I am remodeling a previously tiled shower and replacing with a prefab composite shower floor. The existing drain appears to be cemented into the slab. Will I have to break the slab and remove the existing drain or is there a "magic" adapter that I can use to extend the PVC in order to connect it...

Install shower drain [ 5 Answers ]

I am replacing my shower stall. I need to add 1/2" on top of the existing subfloor, which means the shower drain pipe will be 1/2" lower. Can I still use this, or do I need to extend the drain pipe 1/2"? Is there an easy way to extend the drain pipe (it's only 2 1/4" to the p-trap... so not much...

Shower Drain Install Using Sink Drain Pipe In Wall [ 2 Answers ]

A Feasibility Question: Can a shower drain system be installed utilizing an existing sink drainpipe that is in the wall without raising the shower base above the height of the sink drainpipe location? Some sort of pump or flow system to lift the water for draining? If so, any suggestions as to...

Proper shower pan install utilizing exsting basement shower drain [ 6 Answers ]

I am remodeling a basement bathroom. I demo'd the shower and its tile to reveal rotted framing. I believe this is due to an improper or (more likely) not existent shower pan -- there was no water proof membrane between the tile/thinset and the framing. Can I build a proper shower pan...

View more questions Search