Ask Experts Questions for FREE Help !
Ask
    wulfman's Avatar
    wulfman Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 1, 2012, 05:55 AM
    Threaded PVC for wells
    We are having problems with our deep well we have pressure but, we run out of water quickly. We are going to replace the pump with a submersible pump. Can we use flex water pipe 160psi to hang the pump?
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Aug 1, 2012, 06:51 AM
    There is a flexible well pipe made for this use, use it.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I am trying to find a plug for a 2-3/4 od threaded PVC pipe. [ 2 Answers ]

I have been to the local plumming supply dealers and they have been unsuccessful in providing me a solution. The pipe appears to be an exterior drain that connects to the kitchen sink. This was built as part of the original house when the house was built in 1983. The pipe is white and definitely...

Can I glue pvc threaded fittings [ 2 Answers ]

I have a mix of solvent welded (glued) fittings and threaded fitting pvc piping for my above ground pool fittings. The solvent welded fitting are always leak free, while the threasded fittings seem to leak often. Can I solvent weld the threaded fittings?

PVC threaded plug leaks [ 1 Answers ]

Rain water drain 3 inch PVC threaded plug leaks at low pressure ~ 6 inches H2O - How to stop leak - tape? Liquid tape? Must open from time to time for clean out

New shower valve has threaded unions, old one has non-threaded soldered supply lines [ 2 Answers ]

I bought a new bath/shower two handle 8" spaced valve unit. It has threaded supply unions, but the supply lines are not threaded. What do I need to convert the lines? Can I install stop valve and flexible lines to the threaded valve body hot/cold connections?

Connecting PVC to Threaded Copper fitting [ 2 Answers ]

I have a fitting in a wall which began leaking with mold developing on the wall board. When I took out the wall the culprit was a fitting between a female threaded copper fitting and a male PVC fitting in a hot water line. I initially took out the PVC fitting and fitted the joint with a new fitting...

View more questions Search