 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
92 s10 blazer 4.3 fuel pump inop again
On my s blz replaced fuel pump a few yrs back veh only driven 300 miles then sat for 3 yrs have power going to pump but pump won't engage when key turned on hard to see a new factory pump going bad so quick? I think it was pink wire that had power other 3 wires had no power while cranking. Coil & module was replaced shortley before fuel pump due to spark problem. Hate to pull tank out in a field.
|
||||
Check out some similar questions!
I have a 2000 Chevy Blazer we have replaced the fuel pump and the fuel relay and my the car still won't start. We hooked up the scan tool and my truck won't read it. It cranks but WILL NOT start. Any ideas?
I put a new motor, tranny, and transfer case in my blazer. Got everything hooked up. Now we are finding out that the fuel pump is not pumping any fuel. What do you suggest we look at? We have checked for bent lines and nothing is bent.
I have a 1996 s10 blazer 4wd 4.3 auto. I was driving down the E-way today, had the cruise set at 65mph when it stalled. I had just fueled up so I have a full tank of gas only 8 miles on it. It gave no warning at all just cut out. I felt like I was losing speed so looked down and the rpm was at...
The fuel pump on my chevy blaer test fine, but no power is being supplied to the pump. Fuses and relays test fine, could the EMC cause this issue.
When I turn key to start position, I have power on pump side of relay but when in run position pump side of relay is dead .if I hold key on and keep cranking engine power stays on pump side of relay ,as soon as you let go of key to run pump side dead . If I turn key to run without trying to start I...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
