Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Goodman GMP100-4, no blower fan
[ 3 Answers ]
Light on solid, ventor on, ignition, no fan, flame goes out after 30 sec, ignitor heats up, no ignition, no fan, recycles. Fan works w/fan sw. on stat. Cleaned flame sensor. Same result. Will sometimes work continuously w/fan switch to on and stat in heat mode.
Goodman blower time delay relay?
[ 1 Answers ]
There is a 6 minute delay from when my heat pump compressor comes on until the inside blower comes on. It used to only delay a few seconds. This is a Goodman A60-20 air handler. Do I need to replace the blower time delay relay?
Goodman furnace blower fan issue
[ 7 Answers ]
Just started up furnace for the year. Ran OK for a day. Now furnace ignites then blower fan starts will run, stop for a bit, start again, stops, and eventually it starts again and runs until temp is maintained to thermostat setting.
Goodman Furnace blower (fan) does not start
[ 4 Answers ]
The furnace and blowers is little over a year old. It was reportedly making some screeching noise then stopped and it almost sounded like it attempts to start then it stops. I don't know where and what to look for start trouble shooting. Any help would be appreciated!
Goodman blower fan not working
[ 1 Answers ]
I have a Goodman A32-05 Heat Pump and the blower fan will not start unless I spin it, and then it runs fine. What could be the problem? View more questions Search
|