 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Keeprite furnace 30 second beeping
I have a 1.5 year old keeprite C9MVX060F12A1 model, dual speed DC Motor forced air natural gas. Every hour or so it has been emitting a high pitched beep that lasts for about 30 seconds. From what I can tell it is coming from within the furnace. The view window is emitting heart beat light (manual says this means everything is running fine). What does this high pitched beep mean? I would like to stop it because it is getting very annoying at night, but unsure if it's signalling a problem?
|
||||
Check out some similar questions!
Model c9mpv075f12d1,led code 6 1 reads ;soft lockout for 3 hours but no explanation or remedies.
I have an error 3 flashing dots which means"pressure switch open when should be closed" The unit is 13 months old. I can't get a tech out for 2 days everyone in my area is busy. Any help would be apprecaited.
Between heating cycles the exaust fan comes on,the pilot glows,there is a little green light that flashes on ,off ,in the following sequences , o__000000__0__000000 , this lasts for about 2 to 3 minutes. Then the exhaust fan and pilot go off. No burner ignition occurs during this. This sometimes...
Keeprite Oil Fired Warm Air Model FLO 115 Serial 1367 Age approx 25 years Problem - Started to occur over last 6 months, good for many years Under certain low barometric days no wind, exhaust fumes coming back through burner air in take 88 ppm carbon monoxide.
I have a Keeprite furnace. There is a small plastic pipe 3/4 inch that runs from the furnace Into a 'cylinder' before going into the drain in the basement floor. The cylinder has now turned black inside. My questions are 1. What is this? Is it to do with condensation? ...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
