Ask Experts Questions for FREE Help !
Ask
    andy6d's Avatar
    andy6d Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 5, 2012, 09:11 AM
    Carrier 9200 furnace problems?
    My carrier 9200 furnace blower won't run. I took the blower housing door off and gave the motor shaft a spin and I started. Would that be my capacitor?
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Feb 5, 2012, 03:39 PM
    That's a good starting point. Take the capacitor to your local hvac company and have it tested. If it test bad they will have one to get you back up and going.
    schirvar's Avatar
    schirvar Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jul 11, 2012, 08:21 PM
    My carrier 9200 has large large puddle of water surrounding it
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier 9200 furnace problems? [ 0 Answers ]

Is the capacitor on the blower housing a start/run capacitor?

Carrier 9200 Weathermaker gas furnace -- no heat [ 4 Answers ]

The furnace is about 5-6 years old, and advertised as "ultra-efficient". Gas furnace is inside, Carrier Tech 2000SS A/C is outside. Heat won't come on, despite my reset efforts: -turn thermostat to lowest setting -turn off all electrical power to furnace -remove access panel from furnace...

Carrier 9200 furnace water leak? [ 1 Answers ]

Water appears to be leaking in the area of intake and exhaust system

Carrier 9200 weathermaker [ 1 Answers ]

Have a carrier 9200 weathermaker... when I turn up the thermostat for the heat to come on the small fan starts then the heating element glows... then heating element goes back off... and it shuts back down... I get 3 - 4 code...

Carrier 9200 code 41 [ 2 Answers ]

I have a carrier 9200 furnace flashing code 41 it will ignite and flame but cuts off after blowing for a couple of minutes. Is the moter a DIY project I see the motor cost about $500 online. Thanks a bunch

View more questions Search