a/c heat fan cycle

Check out some similar questions!

Carrier Heat Pump we turned it to heat, inside fan runs outside fan doesn't [ 1 Answers ]

We changed our heat pump from AC to heat, noticed the inside fan ran all night. Checked in the morning and the outside fan wasn't running. Turned it off and back on there is a click but the fan doesn't start. Turned the setting back to AC to see if it would run acts the same as with heat, exterior...

Heat Pump cools, then goes to heat/defrost cycle improperly [ 0 Answers ]

I have an old GE heat pump (over 20 years old) that is I think about a 2 ton or 2.5 ton. The problem is that the A/C aspect is not working right now. I came home the other day to a very hot house. Seems the A/C was putting out heat. So... I shut it off. Then tried it again later. It comes on...

Bryant furnace fan cycles on 1 or 2 times for 2 or 3 sec. After heat cycle has ended [ 8 Answers ]

I have a Bryant furnace Mod. #394GAD024050 and after the temp has reached the set point and the furnace has cycled off the fan will come back on a couple of times for approx. 2 or 3 seconds. In the older furnaces with a machanical fan/limit switch some times the temp would creep up and cause the...

Carrier furnace purge exhaust fan continues to cycle and cycle [ 3 Answers ]

Carrier furnace/AC Product model #58ZAV 075-101JC Model #58ZAV 075-JC Series 100 Serial #2093A16 303 Natural Gas/Propane, heat furnace runs on Propane. Problem: With the unit turned to cooling with the thermostat, the heat pre-purge exhaust fan continues to cycle on and off, sometimes...

Hunter 44155C Wiring - A/C turns on during heat cycle or heat will not shut off [ 0 Answers ]

Trying this again with the correct thermostat specs. Sorry, guys! It's a Hunter 44155C and the wires I have going into it are: White - W/B Red - Rh Green - G Yellow - Y1 Jumper from Rh-Rc

View more questions Search

Check out some similar questions!

Add your answer here.