Ask Experts Questions for FREE Help !
Ask
    bkonk's Avatar
    bkonk Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jul 4, 2012, 04:35 PM
    4 wire to 3 wire relay
    I have an omron LY2 12vdc acting as a relay for a projector screen. I wasn't able to get the screen to move so unplugged everything from the relay (without taking note of how they were plugged in to begin with), and tried to connect the two sides of the power cord to see if that would elicit a reaction. One side of the cord however is 4 wire (connected to projector) and the other is 3 wire... I don't know what to do with the extra red wire and I don't know how to plug it all back into the relay, any ideas on the subject would be appreciated.
    Thanks.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    Jul 4, 2012, 04:48 PM
    You are going to have to dissassemble the switch to get the color of the wires used or do some resistance test.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Explain which wire is ground wire when you have 2 black wires and 1 white wire [ 5 Answers ]

Explain which wire is ground when you have 2 black wires and 1 white wire

Is hot wire is not a neutral wire or vice versa in single phase two wire AC source? [ 1 Answers ]

I am a little bit confused why in AC single phase 2 wire source is merely classified the 1 wire as hot and other wire as neutral. The hot wire travels the current from the source to the load and going back the current to the source through the neutral wire. I know that in AC circuit, the signal or...

Black wire red wire and white wire spliced to 10/3 on a 220 circuit [ 25 Answers ]

I have installed a disconnect between my dryer receptable and a tanning bed. I want to splice the 10/3 box wire to the existing 220 wiring at the dryer. Dryer= red, black, white and bare ground wires 10/3 wire= black, white, and bare ground How do I splice these to allow the disconnect box to...

How to tell which wire is the hot wire, neutral wire and ground wire [ 10 Answers ]

View more questions Search