Ask Experts Questions for FREE Help !
Ask
    Honus's Avatar
    Honus Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 1, 2012, 06:54 PM
    Submersible Pump Troubleshooting
    When the water pressure drops the pressure switch engages but the pump apparently does not turn on for a bit. Sometimes as long as 5 minutes, and seems to be getting worse. Whatnwould cause this? Pump is gould submersible 250 feet down.
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #2

    Jul 1, 2012, 07:15 PM
    Check the points on the switch. They could be corroded. With the power off, give them two or three strokes with an emory board. If that helps, then replace the switch.

    How old is the pump?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Submersible pump troubleshooting [ 2 Answers ]

Not getting water in house from well. Holding tank feels empty Relay switch points look real worn. Could the relay be bad?

Submersible pump troubleshooting [ 1 Answers ]

I recently pulled my pump due to a broken wire due to a broken wire, pressure had been operating fine. Once I reintalled into the casing I had to clear a lot of rusty water from tap screens, diverters toilet tank etc. Since I have reinstalled I have noticed that it will operate fine when called on...

Submersible Pump Troubleshooting? [ 7 Answers ]

Hi, I have nimbus hj 1000 submersible pump fitted in my cooler , and it stops again & again after working for a small duration & sometimes it never works , please help me what should I do to troubleshoot this problem.

Submersible pump troubleshooting [ 1 Answers ]

Hai dear expertist, I have sumersible pump. When I switch ON it does not run automatically, the sound comes like wooooooo. When I rotate with hand it run and becoes very hot within short times. Evey time I start it require manually to run. Please what could be the reason?

Submersible well pump troubleshooting [ 1 Answers ]

Hello: [email protected] We lost electrical power for about 24 hours on my submersable well pump. I can not get any water to rise out of the well. The pump sounds to be fast cycling so I shut it down. On opening the line from the well before the holding tank there is no water present. ...

View more questions Search