Ask Experts Questions for FREE Help !
Ask
    AL88's Avatar
    AL88 Posts: 6, Reputation: 1
    New Member
    		  
    #1

    Jun 30, 2012, 12:59 PM
    1996 Ford Taurus
    I was driving it daily with no problems then I went out to start it and it starts and I can change gears but it won't move. If I put it in drive or reverse and step on the gas it revs the engine. Transmission's fine. Any ideas?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Jun 30, 2012, 01:12 PM
    Check/replace the Transmission Range Sensor (TRS). Verify that the linkage to the TRS is tight and not slipping.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have a 1996 ford taurus that won't go into gear but starts fine. [ 1 Answers ]

I have a 1996 ford taurus and I was leaveing home and soon as I went to put it in drive it made it to reverse and stuck then It would't go into drive I use a little force to try to put it Into drive and no go afther that I went to put it back in to park And it wouldn't go into park. So I...

Why doesn't my 1996 ford taurus shift into gear [ 1 Answers ]

Transmission not going in gear right away, when I first start the car it goes into gear fine, but when I make a short run cut of and go back to start the car it doesn't shift I have to give it a lot of throttle for it to jump in gear

How do I set the ajustment on my linkage cable on a 1996 ford taurus [ 1 Answers ]

My cable from my steering column shifter broke, I replaced it and now I can only go a little ways and it starts revin out and kicking back in, its like it doesn't know where its suppose to be. We adjusted the cable out under the hood but someone says it should be adjusted inside under the dash. But...

Possible hole leaking rain water 1996 Ford Taurus [ 1 Answers ]

Hello, I have a 1996 Ford Taurus, and last year rain water and melting snow drained on to my passenger side floor. When I turned on the heater, you could hear water fly off the fan by your feet. Of course, it burned out my blower moter... and the other part.. (sorry I don't know car parts very...

1996 ford taurus Duratech crankshaft removal [ 1 Answers ]

I am trying to help a friend out w/ his 96 Taurus Crankshaft. It is the original crankshaft and was originally a two piece unit. Anyway, Ford has upgraded the pulley totally and no longer has rubber for a dampener. In the pulley All I know is that I removed the crankshaft assembly which included 3...

View more questions Search