Ask Experts Questions for FREE Help !
Ask
    jim in virginia's Avatar
    jim in virginia Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 17, 2012, 06:52 AM
    Craftsman tiller briggs 5hp
    I have a Craftman 26” front tiller with Briggs &Stratton 5HP I/C engine which has served me well for several years. However it now fails to reach full power. After starting it would conk out when moving from “Choke” back to “Run”. I cleaned the carbureator which is on top of the gas tank including the base of the intake stem and there was an improvement. It would not conk out if set to “Run” but it still will not get to full power. It accelerates OK when throttle is manipulated by hand but will not stay at full power.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Jun 28, 2012, 01:23 PM
    Hi,
    Did you try a new diaphrgm? It is on the side of the carb behind that rectangular plate held on by four screws. One of the most commonly replaced items. Or try:
    Your online source for Replacement Small Engines. Horizontal Shaft Engine Measurements.
    To see how to go with an Intek. Give model and type and I will look it up for you.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Craftsman 5 hp tiller briggs and stratton engine - tiller won't start anymore [ 8 Answers ]

Craftsman 5 HP Briggs and Stratton tiller front tine model 917298352 I bought it yesterday. It is approx 4 years old and was only used twice. I put some gas in it and it started quickly. Ran fine for about 30 minutes and then started revving up and down and then eventually died. I could...

Craftsman II 14" 5hp rear tine tiller model #917.295550 [ 0 Answers ]

Craftsman II 14" 5hp rear tine tiller model #917.295550 Runs good in idle but motor shuts off when tines are engaged

Older Craftsman Tiller w/5hp Briggs and Stratton [ 11 Answers ]

I recently acquired an old tiller that I have gotten to run. It will only run on full choke. It will only till for about a minute or so before going dead. It will idle for a long period, but it's kind of a rough idle. Do I need to adjust the carberator? I have already changed out the gas and...

I have a 5hp Craftsman tiller 298351 Wondering about oiling chain [ 0 Answers ]

The guard around the chain that goes to tines seems completely sealed. There is the shaft that runs through it off the top belt pulley of course. I am thinking since it is completely sealed it might have oil permanently inside? Would hate to screw it up over some maintanence I failed to do, It runs...

I have an older model 5hp 17 inch craftsman rear tine tiller [ 1 Answers ]

Where do I find the model #

View more questions Search