Ask Experts Questions for FREE Help !
Ask
    liz528's Avatar
    liz528 Posts: 1, Reputation: 1
    New Member
     
    #1

    May 13, 2012, 10:55 AM
    Toro20016, won't run
    I purchased a toto 20016 22 inch deck recycler in August of 2006, I used it in 07,08,09,and a little bit in 11. It was drained and stored properly and now I can start it but it won't stay running. I've replaced the oil, the gas and the spark plug. I was looking for a manual to see what else I could do, but I can't find one. Any suggesstions would be greatly appreciated. I have a tiny yard and only mow about every 2-3 weeks.

    Thank you
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
     
    #2

    Jun 28, 2012, 12:27 PM
    Hi,
    This should take you to the manuals:
    https://homeownersolutions.toro.com/...ualsResultPage
    Peace,
    Clarke

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

MY two fans Minkaaire run in the different directions.\r\nHow can I make them run th [ 1 Answers ]

MY two fans Minkaaire run in the differetnt directions.\r\nHow can I make them run the same directions. I tried the on and off switch but it does not help

Admiral model ade7005ayw motor noise will not run when you press to run [ 0 Answers ]

Admiral electric dryer model ade7005ayw motor noise will not run when you press to run

My jeep turns over but won't start. It will run when I put starting fluid but won't run [ 2 Answers ]

My Jeep will will turn over but won't start. I changed the "O" ring in the injectors cause I heard that might be a problem, still nothing. It will start when I spray starting fluid but will only run until it burns through the fluid.

Wiring a ceiling fan in middle of run, outlet at end of run [ 5 Answers ]

I am wiring a bedroom ceiling fan and just needed someone to help me figure out part of the wiring I'm not sure about. The goal is to have a 2 gang switch control the light and the fan separately. The switch is at the beginning of the run, then the ceiling fan, and then I also have an "always...


View more questions Search