Ask Experts Questions for FREE Help !
Ask
    menso's Avatar
    menso Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 19, 2012, 05:00 PM
    Did I damage water heater
    I installed new water heater and crossed hot & cold connections.it worked OK.checked my work 10 hours later and found mistake and corrected the lines . It working fine . Did I do any damage to unit
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Jun 19, 2012, 05:09 PM
    No problem here. All good to go. And hey, these things happen, just good you found the mistake and fixed it. Good job.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

No or very slow hot water from gas water heater, heater makes lot of sounds [ 1 Answers ]

There is problem with our hot water system, not getting hot water while as cold water is OK. Starting hot water there is lot of explosion sort of sounds from water cylinder and hot water will start dribbling and stops after some time.

Can a high water pressure damage my water heater? [ 2 Answers ]

Can a high water damage my water heater?

Instalation Damage to Water Heater [ 2 Answers ]

OK, I know better but for some odd reason I attached then soldered copper too close to the cold water intake nipple of a brand new water heater. The plastic pipe within the metal male threads, on the water heater top, has deformed slightly. I see no external leak when the cold water fitting is...

View more questions Search