 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
How to increase fan speed lennox g20
I have a 2 story house with about 3,000sqft. We have a Lennox G20 Series Unit and I would like to find out if I can increase the flow of air for the AC so it will cool down the upstairs more? If I can't do that I'm open for any other suggestions.
Thanks, Will |
||||
Check out some similar questions!
One of the Pedastal fan in my house is slow over others. Similarly two ceiling fans over others. Both are >5 yrs Raj
I have a Lennox G20 series switched form heat mode to cll and no blower fan but condenser is running, I think it might be a relayon thr control board I'm not sure
I have a lennox G61MPV series furnace. I would like to find a way to increase the fan speed on the fan only mode. It runs at a very low speed and I need it to run faster on fan only. I am installing a outside pellet stove and need to move the air through the new heat exchanger at a faster rate....
Lennox G20 BCC does not keep fan running after heat demand satisfied. This is causing heat build up at the heat exchanger and causing the limit to trip. After the heat exchanger limit resets, the unit will come on again. I have replaced the BCC but the symptom remains. Any suggestions
My Lennox G20 gas furnace ignites the pilot light and starts the main burners. The burners burn normally for about 2 minutes and shut down without the blower fan starting. If I manually set the blower fan to run continuously, the heater cycles on heats the house to the temperature set on the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
