Ask Experts Questions for FREE Help !
Ask
    macosgrove's Avatar
    macosgrove Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 8, 2007, 06:37 AM
    Maple Chase Thermastat
    :confused: My thermastat was flashing LOBAT (low battery?) so I put in two new fresh batteries and it is still flashing LOBAT. Should I have turned it OFF first? How do I fix it?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Mar 8, 2007, 11:22 AM
    Were the batterys you used good ones? Did you put the batters in correctly? Were the contacts in the thermostat clean where the batterys fit?
    Usually if the battery is good the thermostat will not signal low bat.
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
    		  
    #3

    Mar 8, 2007, 03:35 PM
    Remove the cover and look for a very small button (reset) it was on most of the models, and the position of it moved on a few models. Good luck
    charlesfarley's Avatar
    charlesfarley Posts: 1, Reputation: 1
    New Member
    		  
    #4

    Mar 27, 2007, 05:28 PM
    How do you set the schedule of temperatures
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #5

    Mar 27, 2007, 07:08 PM
    Welcome to Invensys Controls

    Go to this link and search for your t-stat.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Maple/ chase thermostat [ 23 Answers ]

I let the batteries run low on my thermostat. I just replaced them but the display still reads "lo bat" and the heat does not kick on. I checked the fuse and it is still intact. Please help!!

Maple Chase Thermostat Question [ 13 Answers ]

This thermostat is at least 10-11 years old I believe. At one point it had a temperature differential of either 2 or 3 degrees. Somewhere along the line it started working with a one degree differential. I have no manual for this and the instructions in the lid don’t say how to change it. Anyone...

Maple Chase thermostat - after electricity went off heat won't kick on [ 3 Answers ]

Have a Maple Chase thermostat -- undetermined age (probably 10 years or so). After electricity went out (and then back on) the heat did not kick back on. Checked batteries and fuse. All seem OK. When I set the fan to On it will just blow out cold air. (Have gas heat). Is there a reset button?...

Maple Chase Thermostat [ 3 Answers ]

Recently my heater turns on irreguarly - one day it will work, another day it may quit. The Heater is Bryant Model 580A packaged gas/electric unit. I have a Maple Chase thermostat in the house. It is about 16 years old. I have someone replaced a new ignition module about two months ago. What may be...

View more questions Search