Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Wiring Hot Tub and using a 50 Amp Double Pole GFCI Circiut Breaker
[ 10 Answers ]
:confused: I keep getting the GFCI breaker tripping after wiring my hot tub. I wired 2 hot Red and Black to the proper terminals and the White to the neutral and the Bare Copper to the ground Post at the tub. I am using 6-3 w/G per instructions. Could the GFCI breaker be bad? When I wire...
Baseboard heater wiring circuit
[ 6 Answers ]
I just finished intaling a baseboard heater and I have a question that has been nagging me. The heater is on 240 circuit. So, I ran 12/2 and used the black and white to run my two hot wires as is common practice. Please excuse my ignorance on this matter, but this got me wondering. I have...
Circuit Breaker Won't Switch To On
[ 4 Answers ]
Hello, I'd appreciate anyone's advice. Today, I realized that one of my condensing units isn't working properly. So I was turning the breakers to both the A/C downstair and upstair units on and off periodically during the day to figure out the problem. Nothing has been solved on that end, but...
Attic conversion circuit wiring
[ 1 Answers ]
hello all and thanks ahead for any helpful advice! I am in the process of converting my attic (cape cod) into living space. Master bedroom (approx 15x28(l-shaped)) and half bath (approx 5x5). Looking for your input on how many/what type of circuits to install. I figured one 20 amp for the 1/2...
Bathroom Vent fan GFCI circuit
[ 3 Answers ]
My NuTone fan says that it's UL approved for over shower use when wired with GFCI circuit. Would it be acceptable if I ran the fan power wire first through a plain face (non-outlet, but outlet sized unit) GFCI unit, through the switch and to the fan with nothing else on that circuit? I know that I... View more questions Search
|