Ask Experts Questions for FREE Help !
Ask
    Tracy Berry's Avatar
    Tracy Berry Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 13, 2012, 10:24 PM
    Broken,something in my steering wheel/colum of my 88 chevy truck
    How can I fix a steering wheel that can be moved back and forth,up and down about an inch or more, but is still drivable,and the tilt mechanism still works?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    Jun 14, 2012, 06:10 AM
    Remove the steering column cover and inspect exactly what the problem is. Loose and damaged parts are not too hard to service.
    CaptainRich's Avatar
    CaptainRich Posts: 4,492, Reputation: 537
    Cars & Trucks Expert
     
    #3

    Jun 14, 2012, 09:05 AM
    What has probably happened is one of the pivot pins for the tilt system has come loose. Normally, they tend to back out and allow that excessive movement but still seem to function fairly well.
    Remove the steering column covers to inspect. If it is just the pivot pin, it can be gently driven back into the pivot once the holes are aligned properly. If you apply inward pressure while jiggling the steering wheel to assist in aligning, you can find where the pin begins to fit and once you're sure it's lined up, gently tap it in until it fits flush.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1996 GMC / Chevy S10 Blazer Steering Wheel Removal [ 2 Answers ]

I need to remove the steering wheel on a 1996 GMC S10 Blazer with tilt. I am already familiar with disabling and removing the air bag, and removing the nut that holds the steering wheel to the column. Chevy has a special puller to remove the wheel. My question is, can I use a generic puller...

How to remove 1999 chevy tahoe steering wheel? [ 0 Answers ]

I have a chilton manual and it tells me to remove the four springs on the back of the steering wheel. I have two torx screws holding the steering wheel rear cover on. Do not see four springs as per manual. Can you help [email protected]

I want to know how to remove the steering wheel of chevy blazer [ 1 Answers ]

I'm replacing the beam switch on the steering wheel ,the steering needs to be removed in order to do that, please tell me how can I remove it? Thank you

Chevy Blazer steering wheel removal [ 1 Answers ]

I would like to know how to remove the factory steering wheel with air bag. For the installation of an aftermarket wheel. Without airbag.

1954 chevy steering wheel and horn [ 1 Answers ]

Am trying to figure out the correct way to assemble the steering wheel and horn ring section on a 1954 chevy. I have a large steel (looks like a washer) and a clear plastic ring. Do these go in behind the steering wheel or under the orn ring between the horn ring and wheel? Can't find the answer...


View more questions Search