Ask Experts Questions for FREE Help !
Ask
    Bustie1's Avatar
    Bustie1 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 13, 2012, 11:55 AM
    Governor for 8 hp B&S lawn tractor
    I have just cleaned the carb of an old Toro/Wheelhorse 8hp B&S rear engine rider mower. When I reassembled the cables, and started it, it now races with no control by throtle. Please if you have a diagram of the proper setting for the linkage of the Governor, I may have it set wrong. Any other ideas?
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Jul 8, 2012, 06:41 PM
    Hi,
    How about the model and type numbers off that engine so that I give the right one.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Were is oil filter on 2005 mtd lawn tractor, hydrostatic lawn tractor [ 1 Answers ]

Were is the oil filter located on a mtd hydrostatic lawn tractor.

Remove cover on B&S Lawn Tractor engine [ 1 Answers ]

How do I remove cover to get to the solonoid/starter on Briggs and Stratton 13.5 hp lawn tractor engine?

Craftsman lawn tractor B&S 18.5 hp crank no start [ 7 Answers ]

Getting mower ready for first time use this year. It will make a revolution when tried to start, but that's it. Normal maintenance was performed, changed oil, plug, air filter, charged battery. Tried jumping the rider with my truck, same result. Tried jumping the starter directly, same result....

Briggs & Stratton 17hp Lawn Tractor [ 6 Answers ]

Why is gas leaking into air filter at low throttle?

View more questions Search