 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
State select water heater troubleshooting
I have a State Select Gas Water Heater GS650YBVIT Power Vent. I had my wood floor sealed with oil base sealer and the water heater went into item 15 in the instruction manual "the gas control valve has detected the presence of flammable vapors. It has been three days since the wood was sealed. I have placed a fan at the water heater. Turned it off all night and still no luck. It will not go out of this mode??
|
||||
Check out some similar questions!
Our hot water heater was working perfectly fine then we had a water main break down the street. We were without any water for a day, and when we finally got water it will not get hot HELP
Propane water heater modelPR650CCVIT no hot water exhaust fan is running .on the controler the vacation light is on the one in the middle is on and the one on the far right is on that says very hot. I go and push the two arrows to relight it and then the center light should blink and fire up but...
I have a State Select water heater. It is continually dripping water from the relief valve opening. Otherwise, it appears to be functioning normally. Can you tell me what the problem is?
I have state select water heater and it went on vacation mode how to bring it back in regular mode?
We have a State Select instant water heater that is about 3 years old. It serves a single small sink in a room that is rarely used. Tonight it started to leak. I unplugged it, shut off the water at the isolation valve and opened the drain valve. Less than 1/2-cup of milky-looking water came...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
