How to by pass an oil sensor on a briggs stratton

powerman123 Posts: 1, Reputation: 1

New Member

Jun 9, 2012, 03:22 PM

How to by pass an oil sensor on a briggs stratton

How do I by pass an oil sensor on my briggs stratton?

crigby Posts: 4,343, Reputation: 107

Outdoor Power Equipment Expert

Jul 8, 2012, 05:10 PM

Hi,
Disconnect the wire.
Peace,
Clarke

Add your answer here.

Check out some similar questions!

14.5 Hp - briggs and stratton gas in oil - [ 5 Answers ]

14.5hp Briggs and Stratton OHV - 287707 Engine Mode - Gas in Oil - Ok guys - I'm Stumped I have gas in the oil. It runs for 15 seconds, then stalls in a cloud of smoke. I read the forums and thought it was: 1) Carburetor problems - I checked the carburetor and the float is...

12.5 HP Briggs and Stratton oil leak [ 8 Answers ]

First day of lawn season, cut the lawn after a difficult start. The next day put a new air-filter, fuel-filter and spark plug. Looked under tractor and found a puddle of oil. Pulled dipstick and it was empty. The main pulley was completely full of oil. Any ideas?

How much oil goes into a briggs and stratton 16 hp motor [ 1 Answers ]

How much oil goes into a briggs and stratton 16 hp motor

15 HP Briggs and Stratton, Oil in Carb [ 1 Answers ]

Briggs 15 HP OHV, Model 311707, type 0138-E1, code 010228ZE. 151 hours on engine. Large volume of oil being blown into carb/air cleaner. Heavy clouds of gray smoke. Oil level on dip stick normal. Engine loads up and dies. What are possible causes and solutions? Woodman 65

15.5 Briggs & Stratton, How much oil? [ 1 Answers ]

:( My husband is trying to change the oil on a 15.5 briggs & stratton (riding mower) - he cannot find anywhere where it tells him how much oil needs to be replaced, and he does not want to put too much in. Can someone please help? :)