Ask Experts Questions for FREE Help !
Ask
    Dflushing's Avatar
    Dflushing Posts: 1, Reputation: 1
    New Member
     
    #1

    May 30, 2012, 08:06 PM
    Huskee Riding Mower Clutch
    I have a huskee riding mower and we just replaced the drive belts. They are too tight so the clutch will not engage fully until it had run for quite a while. After it warms the belt enough, it will engage better. It still does not engage to its full potential, however. Is there a way to just adjust the clutch so it will work? Or any other advice you could give me would be nice. Please help soon. Thanks.

Check out some similar questions!

My huskee riding mower start missing when I engage the mower deck 17.5 hp briggs [ 1 Answers ]

My huskee riding mower 17.5 hp briggs ! Starts missing running bad when I engage the mower deck

Huskee riding mower won't go into gear [ 3 Answers ]

I've had a Huskee LT4200 riding mower for several years with no problems; runs like a top until... Yesterday I idled the mower to empty the grass catcher but then couldn't get the mower to move. When I engage the transmission catch (in lower back) in order to push it to the garage to look at it,...

2005 Huskee riding mower PTO won't engage and mower dies [ 12 Answers ]

Replaced battery with new one, within several starts the new battery was drained. Mower will start by jumping but only runs a few minutes then dies, also the PTO will not engage at all (replaced PTO switch and still won't engage) does not even attempt to engage, as if there is no power to the...

Huskee riding mower clutch issue? [ 10 Answers ]

I have a newer (2005) Huskee riding mower with 50" cutting deck. Mower was working fine, then suddenly the blades stopped cutting and pulleys stopped turning. Now I cannot get the clutch to engage at all. Do I need to replace the clutch? And is this something I can do myself?


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.