 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Harden shower tub control
Great answers and picture, mass plumber, but how do you remove the cartridge? A screw head is shown about 3/4 inch to the right and slightly below the cartridge shaft. Does this screw have to be removed to replace/clean to get at the cartridge. Also, in my case there is still a very slight drip, apparently from the hot water side. but if I can clean and/or replace the cartridge, it may not be too messy.
|
||||
Check out some similar questions!
I live in a condo that was built around 1989. After the HOA replaced the shut off valves for my unit I noticed a problem with the shower valve in my second bathroom. Hot water does not come out. Hot water works fine from every other faucet, but when I turn the shower valve to hot the water slows to...
Need the two cylinders (first two attachment pics). House was built in 1954, assuming this is original equipment. Had to replace them once before (plumber found them somewhere), would like to replace them myself this time. They wear out and chatter, and don't allow for good hot water control...
We are trying to install the water control for a Glacier Bay tub/shower fixture. The instruction state to make a 6 in diameter hole for the control template back and it is to be flush with the finished wall. Well, what will keep this from pulling through as it is not secured to anything. We...
Gutted bathroom. Installing new fixtures with new locations. Need to know what the recommended distance the spout is from the tub. The distance the spout is from the one hand control and the distance from the one hand control to the shower head. I read the spout is 1" from the tub, the one...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
