Ask Experts Questions for FREE Help !
Ask
    libbysout's Avatar
    libbysout Posts: 1, Reputation: 1
    New Member
     
    #1

    May 16, 2012, 09:34 AM
    Parts husqvarna lgt2654 engine shooting oil out of block
    Parts husqvarna lgt2654 belt keeps jumping off pulleys

Check out some similar questions!

Problems with husqvarna 2554 with Kohler engine [ 9 Answers ]

I have a Husqvarna LGT 2554 with a Kohler engine. Engine starts and runs fine for about 30- 45 minutes then just dies. Let sit for a while and then starts and runs fine for about 30 minutes. Repeat. Repeat etc. mower is less than two years old and has low hours. Only use it to mow my yard. ...

Husqvarna LGT2654 Engine Briggs Model No. 445877 [ 5 Answers ]

Engine lost power then wouldn't start. Serviced Engine but still no start. I had trouble when it was brand new and it did this, Repair Facility said it had stuck valves and I needed to use better gas. Now I get clean High Octane. But my Wife said that she bought Regular last time. So I took the...

Husqvarna YTH2448 engine stalls when blades engaged [ 5 Answers ]

Good afternoon all, I have a quick question that I am hoping someone can help me with. I have a Husqvarna yth 2448 that stalls when the engine is engaged after running for about 30 minutes. After the mower sits and cools off, it will cut fine again. I checked the seat sensor, not sure if that...

Husqvarna 155 rider - 15.5 hp kohler engine removal [ 1 Answers ]

Hi folks. I have a 15.5 vertical shaft Kohler Command engine (CV15S) that I am attempting to remove from the tractor frame. Think it threw a rod! All bolts and connectors on engine are removed except the vertical shaft. I am requesting help on procedure to remove shaft from tractor that includes...

Husqvarna BT-130 backpack blower; engine speed [ 5 Answers ]

I have just purchased a Husqvarna BT-130 backpack blower and it runs at about half speed and does good to move a blade of grass. I have read the owners manual trying to find carb adjustment instructions. All it says is after about 10 hours of run time, take it to a qualified Husqvarna technician...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.