Ask Experts Questions for FREE Help !
Ask
    HWCART's Avatar
    HWCART Posts: 2, Reputation: 1
    New Member
    		  
    #1

    May 14, 2012, 11:45 AM
    CFL bulb in new light fixture tripping breaker
    I just installed a new light fixture in the bathroom. I had the breaker off and when I finished installing I put in a CFL bulb and turned on the breaker. I immediately heard a pop and noticed the breaker was tripped. I checked all my connections and reset the breaker. The light stayed on for about 15 minutes before the breaker tripped again. After that I put in an incandescent bulb. It has been on about 2 hours and the breaker hasn't tripped. Is it possible that the CFL bulb caused the breaker to trip and I should only use incandescent bulbs?
    Chic_Bowdrie's Avatar
    Chic_Bowdrie Posts: 54, Reputation: 8
    Junior Member
    		  
    #2

    May 14, 2012, 01:40 PM
    First of all, is anything else on the circuit you are working ON? You probably have at least a 10 amp breaker (probably more) on a 120 volt circuit. If your bulb is 60 watts, you are drawing 0.5 amps. That is way too little for the bulb to be the problem by itself. A breaker will trip when you exceed the amps it is rated for. Since the incandescent bulb doesn't trip the breaker, your CFL bulb would have to be pulling more amps than the incandescent one. That would be unusual. What is the wattage of the CFL?
    HWCART's Avatar
    HWCART Posts: 2, Reputation: 1
    New Member
    		  
    #3

    May 14, 2012, 03:01 PM
    The kitchen, hall, and utility room lights are on the same breaker. The CFL was a 13 watt. The incandescent is 60 watts.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #4

    May 14, 2012, 06:31 PM
    The CFL could have a ground fault in it. Is the light on a GFCI breaker? If so, try another CFL.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #5

    May 14, 2012, 07:33 PM
    I'm with ma on this. Sounds like the bulb has a fault, not the first time for a cfl to be bad from the box. Both great answers. You got a bad bulb.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #6

    Jun 14, 2012, 03:16 PM
    Also look in the socket to see if center tab is bent over, touching?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I keep replacing the halogen bulb in my light fixture once a week? [ 2 Answers ]

I use 0ne 150 watt bulb as light fixture says per week can not find out why they go so soon

Hamton Bay outdoor light fixture... how to replace a dead light bulb. [ 0 Answers ]

I have to see if one of the glass panels slides up or down or left and right. It does not appear that the top or bottom is removable. Don't have instruction guide... don't know the model number

Changing from 300 watt light fixture to a 52" ceiling fan w/ 2 13w CFL bulbs [ 7 Answers ]

As I understand it, I should be safe using the same wiring. However. The no. of wires, and their configuration when I removed the light fixture (5-60watt candelabra-based bulbs), has me seeking assistance. By the way. I did turn off the circuit breaker. There are three sets of wires coming...

New light fixture tripping breaker [ 3 Answers ]

I have been trying to replace a three bulb dome light fixture in my kitchen and it keeps shorting when I turn it on. The house wires are a little old but not frayed. There are no apparent bare wires. Even I as a novice can attach black to black and white to white, put on wire nuts, and push them...

Light-bulb change in HB fixture? [ 2 Answers ]

The condo unit I bought has a Hampton Bay light fixture in the kitchen (flushmount, 2-lights, 60w, frosted glass)... this sounds funny to type these words, but how do I change the bulbs? Does the glass portion unscrew? Does the fixture pull-down from the ceiling? I am very hesitant to monkey...

View more questions Search