Ask Experts Questions for FREE Help !
Ask
    Molei's Avatar
    Molei Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 3, 2012, 04:02 PM
    My 94 honda accord lx stalls while slowing down n sometimes when accelerating.
    My 94 honda accord lx stalls while slowing down and sometimes when accelerating. It also boggs then go good bur when it dies out it will start right back up with no problem.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    May 3, 2012, 04:22 PM
    Replace the Ignition Control Module (ICM) and coil. Apply silicone heat transfer grease to the back of the new ICM.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1990 honda accord throbs and pulses while idling or accelerating.. [ 6 Answers ]

1990 honda accord throbs and pulses while idling or accelerating.. car drives fine until it warms up.

96 honda accord stalls and won't start [ 1 Answers ]

2003 Honda Accord EX making noise when idle and accelerating [ 2 Answers ]

My 2003 Honda Accord EX V6 makes a noise when it's idle and when I accelerate (Kind of like a high pitch noise similar to an Airplane engine) It seems to be coming from the alternator area, but it starts up just fine. Would you know what that could be?

Honda Accord 1986 stalling when accelerating [ 1 Answers ]

3 Door EX, carburetted model. 1800cc 12v, ET1 engine. Car stalls at red lights and going uphill. If I keep it in 2nd point of choke then it will not stall but RPMs at neutral etc will be sky high. I have 1) used a fuel cleaner. No effect 2) cleaned and refitted carburettor. No effect...

Honda Accord stalls 1992 [ 1 Answers ]

Car died flat out when driving. Discovered the distributor was bad and I (personally) replaced it. (sounded slightly out of time, but I only use it for 4 miles one way, so left it) Stalled about a week later. I replaced the rotor and distributor cap and put in new plugs. Still stalled. I had...

View more questions Search