Ask Experts Questions for FREE Help !
Ask
    bob denis's Avatar
    bob denis Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 29, 2012, 10:48 AM
    No cold water in my single handel moan tub valve
    I have a moan single valve tub valve with no cold water. After 7 years of use

    No cold water in my single handel moan tub valve. It has worked for 7 years
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    Apr 29, 2012, 12:17 PM
    Hi and Welcome to The Plumbing Page. At AskMeHelpDesk.com. You piggybacked on to a anthers thread so I gave you one of your own.
    Turn the water off tom the valve and remove the cartridge. Check and clear the inlet port. Now turn on the water for a moment to flush out then supply. (you should see a strong stream when you do this. Reassemble and test. Good luck. Tom
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have a single cold water valve in a bathroom that bangs after a few seconds [ 4 Answers ]

Once I turn on the water it runs fine for a few seconds then the flow slows to about half and the banging begins. If I open the cold water valve on the bathroom sink directly behind the problem sink and then open the problem valve there is no banging. I have drained the system a couple times and...

Single Handle Shower pressure valve leaking cold water only [ 0 Answers ]

When I am using my shower my single handed shower is leaking only cold water. It is leaking into the floor below it, and is not a constant leak. It only happens during water running. When shower is hot the water leaking is cold. I believe it is the Pressure valve but not too sure. Any ways to...

My single lever tub shower moen valve will only give all cold or all hot water no w [ 1 Answers ]

My single lever tub shower moen valve will only give all cold or all hot water no water comes out when the valve is in the middle position. Any help.

Mixing valve tub/shower with no cold water [ 1 Answers ]

I'm flummoxed with a Delta, mid-1990's mixing valve. The valve has shut-off's via screw and locknut on cold and hot inlets, and I have good pressure there at both hot and cold side. But an inch-or-so away, at the main body holding the cartridge (I don't know the terminology, sorry), no cold...

Plumbing: I have a single knob on my bath tub that controls the hot and cold water. [ 3 Answers ]

We "had" our plumbing problem "fixed" by a pro. It still does not work. Our upstairs bathroom has both hot & cold water when a sink facucet is turned on. But, in the bathtub, only the cold water works. Had it "fixed" almost a year ago, just had company, and there is no hot water coming out of...

View more questions Search