Ask Experts Questions for FREE Help !
Ask
    paulywog63's Avatar
    paulywog63 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 21, 2012, 08:08 AM
    Goodman / no flame
    Goodman 80plus unit goes through set up/draft inducer/ok new hot surf ignitr -glows relay clicks
    And no flame ingitr clicks off and unit begins the start up again and yes there is a gas supply. Hope u can help me thanks.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Apr 21, 2012, 02:42 PM
    Check for 24v to gas valve when the relay clicks to kick the gas valve on (this will be between the time the glow plug starts glowing and shuts down) If you receive 24v to gas valve, but no gas flows (using a monometer to see if gas is actually being delivered to the burners is the best bet here) then you most likely need a new gas valve. Definitely some testing needs to be done to know for sure what the problem is.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman Furnace Flame sensor? Help! [ 2 Answers ]

Having an issuse with my goodman furnace. Fan turns on, Ignitor turns red, flame comes on, and then goes out then blower motor comes on. Repeats 2 or 3 times and stops. The led is a steady red. I have replaced the circuit board, flame sensor, flame sensor wire, and the 24v transformer chassis...

1999 goodman furnace flame cycles on and off. [ 0 Answers ]

Goodman furnace appears to only have a heat sensor and a flame sensor, I sanded the flame sensor,it had some dark spots on it and I examined the heat sensor but it appears normal it does have a clicking noise in it when shooked back and forth? System runs OK but flames are cycling on and off so not...

Goodman furnace runs but not always with flame first [ 0 Answers ]

My Goodman furnace sometimes starts up, vent fan, then the gas does not ignite or even appear, then blower runs through its cycle and shuts off, blowing unheated air around. It does this about 30% of the time now. A HVAC pal filed off the igniter rod saying it was corroded. He said there was...

Goodman furnace igniting but blowert blowsm out the flame [ 0 Answers ]

I have a goodman gas funrnace model# GMS8070NBC. Furnace ignites but as soon as blower kicks on the flame goes out. Tries to do this every couple of seconds. What do you think the problem is?

Goodman 90 plus furnace flame sensor [ 6 Answers ]

Goodman furnace is showing single blink every 2 seconds. I see that a possible problem is the FLAME SENSOR. My main question: Is the flame sensor the SAME part as the ceramic ignitor ? If different, where is it in relation to the ignitor ?

View more questions Search