Ask Experts Questions for FREE Help !
Ask
    Ktrapnell's Avatar
    Ktrapnell Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 11, 2012, 02:28 PM
    How do you wire a amp meter for craftsman riding mower
    The craftsman riding mower's amp meter was removed, I don't know where to splice the new amp meter in
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Apr 11, 2012, 02:32 PM
    Are there any wiring harness parts left open/dangling?Model number would be helpful
    Ktrapnell's Avatar
    Ktrapnell Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Apr 11, 2012, 06:59 PM
    I should have included that from the beginning. The mdl# is 917.257090. The wiring harness is complete, however, there are no loose wires. The wires are all spliced and I can't figure out which wire goes where. A owners manual came with it, but the schematic is not readable. It does look as though the amp meter gets wired in after the inline fuse on one side. The other side appears to go the ignition harness, but which wire. Hope this helps get to a solution
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #4

    Apr 12, 2012, 01:12 PM
    Hi,
    Few manuals seem available, but here is a picture of the wiring harness. It is item #12 and the hardware is #F.
    Peace,
    Clarke
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

60 AMP feeder line to meter and from meter is 200 AMP wire to my electrical box. [ 13 Answers ]

I have a old 60 AMP feeder line from the top of my house to the meter. From the meter is 200 AMP new wire. I was wondering if this is even safe and what would the cost be of updating the feeder line?

I have a B&S 15hp engine on a craftsman riding mower. It will start and run for 5 sec [ 0 Answers ]

I have a B&S 15 hp engine on a craftsman riding mower. Engine cranks and runs for about 5 seconds and cuts off. I have new fuel filter, new plug on it. I was given the mower so no background on it. Any suggestions?

Craftsman 17 hp riding mower replaced the solenoid & still no power to engine [ 1 Answers ]

I have a craftsman 17.5 horse riding mower, it was working and I parked it for about a week and now it won't start, the battery if fine.. I replaced the solenoid because there was no power going to the starter. Same preblem with the new one, if I jump the solenoid it will turn over.

15.5 briggs & Stratton "Craftsman Riding mower [ 7 Answers ]

I have a Craftsman 42" Riding mower that's approx 5-7 years old. It runs great when it runs, but when I try to start it up is when I run into trouble. Ive replaced the battery... brushes in the starter... fuel filter... cleaned all the battery connections including the ground on the frame. It...

Craftsman Briggs & Stratton 15.5 Riding Mower Want Start [ 16 Answers ]

I have put in new battery, new solenoid switch and my mower still won't fire. No sound at all. What seems to be the problem?

View more questions Search