Ask Experts Questions for FREE Help !
Ask
    HelpinCalif's Avatar
    HelpinCalif Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 10, 2012, 10:16 AM
    Replacing a Gas Water Heater Manifold Door
    I have a Gas Water Heater and was just shipped a new Manifold Door. I have disconnected the 3 connections to the thermostat and taken out the two screws to pull out the old manifold door... But it won't budge. How do you get inside to see if the tubes on the inside are screwed into the orifice which in turn is screwed into the gas burner plate? There is no room to get behind the manifold door?
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #2

    Apr 11, 2012, 06:21 AM
    First, what kind / brand / type of water heater is it ? Please, provide us with this information so we can advise you further. Back to you. Milo
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Low hot water pressure through the whole house even ater replacing water heater [ 2 Answers ]

I'm still experiencing low hot water pressure even after replacing the water heater. When you first turn on the faucets the pressure will be fine but within a few seconds it drops again.

Order of water heater, pressure tank, and pex manifold [ 5 Answers ]

Part of a major remodel that I am doing requires me to move the utility room further away from the main water supply feed and run new water lines to every fixture. I am going to be using a pex manifold in this system. Because of a couple different reasons that I won't waste your time explaining...

Very low water pressue to house after replacing leaking valve on water heater [ 1 Answers ]

I replaced the leaking valve leading to the hot water heater, drained the hot water heater, turned the main valve to the house back on and now have very low water pressure to the house (cold and hot) The house has galvanized metal pipes... HELP please!:confused:

Replacing Door Switch in Whirlpool Gas Dryer [ 2 Answers ]

I am replacing a door switch that broke off on my Whirlpool Gas Dryer. I have searched the internet for instructions on how to replace it (I have located the replacement part and purchasing the part today) but have had no luck in locating instructions on how to replace the part. I am hoping to...

View more questions Search