 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Why would I have hot water pressure but no cold water pressure
Ok so I bought my house in 2007 in 2009 I had all the plumbing redone to copper because I had a problem with no cold water pressure.But that didn't help,I was told I needed a new hot water tank so I bought one,That didn't help with the cold water pressure.Now I'm needing help to figure this out as I asked many people already and they don't know what could be wrong.
And just to say I have great hot water pressure. Please someone help me. Thanks |
||||
|
||||
|
Hi mystix and Welcome to The Plumbing Page. At AskMeHelpDesk.com. A few questions before we start. Pump or city water? Do you have a water filter or water softener installed? When the repipe job was finished and you still had no hot water what were you told? What excuse were you given?
Back to you, Tom |
||||
|
||||
|
Tell us more about your house too. How many fixtures and is the hot good everywhere and the cold bad everywhere? Apparently the cold is good up to the point where it feeds your water heater, otherwise you'd have low hot VOLUME too. BTW is volume and not pressure that you have a issue with in this case.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hi, I own a small plumbing service and have a problem I've never encountered before. I installed a new top vented gas water heater for a customer. Turned the main back on, bled air out of the lines, etc. Problem is there is no hot water pressure throughout the house. Cold water pressure is fine....
I have a single faucet sink where the cold water pressure is fine and all other sinks have good hot and cold water pressure. I replaced the kitchen faucet two years ago along with new lines. As of late I'm getting very little hot water pressure along with having to run the water for about 10...
I just had my water heater replaced and was given an energy star eco-friendly unit. But since the replacement, whenever I try to take a hot shower or fill my bathtub, the hot water trickles out almost like the faucet isn't open all the way but it is. The cold water comes out fantastic.
I have already cleaned the Megaflo cold water valve unit. The Megaflo Heatrae Sadia is only 3/5 years old. What should I do?
We have very low water pressure at our kitchen sink from both the cold and hot water faucets, but no problem with the water pressure to the bathroom or washer. The cold water tank is closest to the kitchen and the hot water heater is near the bathroom and washer. Someone told my roommate that there...
View more questions Search
|
