Hot water tank not filling

eddieparker Posts: 1, Reputation: 1

New Member

Mar 28, 2012, 06:12 AM

Hot water tank not filling

My cold water header tank is not filling the hot water tank.

Milo Dolezal Posts: 7,192, Reputation: 523

Plumbing Expert

Mar 28, 2012, 09:32 AM

Turn cold water valve above the heater to ON position. Back to you. Milo

Add your answer here.

Check out some similar questions!

Why is the cold water line not filling my hot water tank ? [ 5 Answers ]

The cold water supply valve to the water heater is open, but no water is flowing. I opened the drain valve on the heater and no water came out. Obviously it hasn't been filling for the past few days. I have plenty of cold water at all my faucets. I have shut off the breaker.

Replaced a hot water tank,water is not going to the pressure tank-the pump stays on [ 2 Answers ]

Replaced a hot water tank, turned the pump on and the water is bypassing the pressure tank. The pressure tank will not fill up and the pump remains on and will not shut off. We do get water though but needs to shut off the pump so it will not burn out. Any thoughts? Thank you Any ideas will...

New Hot Water Heater Wire Panel Filling With Water From Tank [ 2 Answers ]

I have recently installed a new electric hot water heater. I have connected all the wires properly, I have connected the piping in the correct manner, and filled the tank. I was about to flip my breaker to turn the water heater on, and noticed a little moister around the panel that the wires come...

Toilet Tank not filling after hot water heater fix! [ 1 Answers ]

Folks after changing out the element in my hot water heater today (which involved shutting off the water to the heater, draining and refilling it) one of my toilets will not fill the tank after a flush. Any ideas what can be causing this? Thank you.

Rainsoft Water Softener - Salt tank not filling with water? [ 1 Answers ]

Put a bag of salt in my softener today and it appeared to be way over the brine level. Checked on it a few hours later and still had dry pellets on top. Manually regenerated the system - no fill. Letting it go through its cycle now, but wondering if there's something I'm overlooking. There's...