 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Kenmore Ultra wash quietguard 4... Water in bottome does not drain
Our Kenmore Ultrawash quietguard 4 washes the dishes fine. However, a few inches of water stays in the bottom. Any ideas regarding what fixes to try? Thank you. (We are new home owner.. Do not know history of machine nor have any manuals).
|
||||
Check out some similar questions!
The problem I amhaving with it is when you put it on a cycle it will run for a bit then shut off sometime it will come back on and run for a little while long 30 sec. to a min and sometimes you have to push cancel to get it to start . You have to do this all the through the cycle is there anyway...
We have been scooping water out after we run a load. The cycle does run through, including the drain cycle, but the water is not draining. I do not see a "float" as mentioned on a previous posting. I hear sounds as if draining is taking place, but of course it is not draining. If a pump needs...
Hi, we inherited a Kenmore ultra wash dishwasher with a house 2 years ago. It has worked reliably until last week. Now there is about 2" of standing water in the base. I ran it through the cycle once to see if it clear it out but it didn't. Any suggestions? We normally are very good at rinsing off...
The dishwasher gets stuck in the "washing" cycle. I've already reset it using the "heated dry then normal wash, then heated dry-normal wash". Any ideas before we give in and call Sears?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
