Ask Experts Questions for FREE Help !
Ask
    DougA's Avatar
    DougA Posts: 5, Reputation: 1
    New Member
     
    #1

    Mar 17, 2012, 03:34 PM
    Briggs&stratton 14hp
    I need to know where the wire goes that plugs into the fuel solenoid on a nikki carb on a briggs and stratton 14 hp motor.
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
     
    #2

    Mar 17, 2012, 03:36 PM
    How many wires does it have ?
    DougA's Avatar
    DougA Posts: 5, Reputation: 1
    New Member
     
    #3

    Mar 17, 2012, 03:37 PM
    Just the on
    DougA's Avatar
    DougA Posts: 5, Reputation: 1
    New Member
     
    #4

    Mar 17, 2012, 03:38 PM
    Just one I meant
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
     
    #5

    Mar 17, 2012, 06:28 PM
    There should be a spade on the bottom of the solenoid , it plugs in there.
    Luck
    DougA's Avatar
    DougA Posts: 5, Reputation: 1
    New Member
     
    #6

    Mar 17, 2012, 06:45 PM
    Well I kind of figured that but where does the other end suppose to connect too?
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
     
    #7

    Mar 17, 2012, 07:57 PM
    Sorry my bad . It goes to the hot wire in the engine plug,
    Turn key to on not running check for current in plug there is only one hot when engine is not running .
    Luck

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

14HP OHV I/C Briggs & Stratton Problems. [ 15 Answers ]

I purchased this motor used around July of 07. I believe it came off a Murray riding lawnmower. It ran fine for the first three months (occasional smoking) or so then after a 2 week break of cutting it was hard starting. Took about 2-3 minutes but it started, a little smoke at start up, I made a...

14hp Briggs and Stratton blows smoke/oil out exhaust [ 6 Answers ]

I was given a neglected zero turn mower that had been used regularly for the past several years. After charging the battery I started it up and let it idle for a few minutes before trying to move. I did notice that it seemed to be smoking a bit and once I increased the speed, the engine blows a...

How to adjust valves on 14Hp Briggs&Stratton engine [ 1 Answers ]

The lawnmower will not crank, has too much compresssion. The engine will not turn over.

Compression release 14hp briggs stratton [ 1 Answers ]

How to adjust compression release 14 hp briggs engine ohv,

Briggs &stratton 15 hp. [ 1 Answers ]

The other day this engine just quit and I had no spark from the coil. It has the electronic ignition so I cleaned everything under the flywheel and put it back thinking that this must be the problem but no. There is a small wire that goes to the coil and when I pull it off it will fire. I found two...


View more questions Search