Ask Experts Questions for FREE Help !
Ask
    Lynn84's Avatar
    Lynn84 Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 8, 2012, 02:32 PM
    Van won't go into gear even though the gearshifter is.
    I went to start my 03 Ford Windstar and put it in reverse but it wouldn't go anywhere. I tried putting it in drive and it still wouldn't budge. I moved the gearshifter up and down slowly to see if I could hear it go into gear but there was nothing. I shut my van off and tried it again, still nothing. I checked the tranny fluid, that was fine. What do you think the problem is? Is it going to cost a pretty penny?
    CaptainRich's Avatar
    CaptainRich Posts: 4,492, Reputation: 537
    Cars & Trucks Expert
     
    #2

    Mar 9, 2012, 06:38 AM
    Check to see if the shift cable is moving when you move the shift lever. You'll need to do this with the engine off and someone looking at the cable while someone else is moving the lever.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #3

    Mar 9, 2012, 07:26 AM
    If the problem persists, focus on the Transmission Range Sensor (TRS), located on top of the transaxle. It may need adjusting or replacing. Test all under hood and under dash fuses with a test light or multimeter. Finally, check for codes.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gear box reduction & gear [ 0 Answers ]

My plant consists of drum of about 7feet dia and 23 feet length the drum when full loaded bears weight of 10 tons including the weight of drum. This drum is to be rotated at 0.4 rpm can u help me in getting the gearbox turn ratio & gear type & no of teeth to be used for it

Car gear not switching to 2nd gear [ 0 Answers ]

My toyota 98 camry can't switch form 1st to 2nd gear, Goes reverse.. Dashboard is off at the same time, no speed no rpm, no temp. please help

Repalace ring gear gear on brigg and sratton 14.5 engine [ 1 Answers ]

How do you removed the ring gear from the fly wheel and put on new one on the teeth is worn out and the starter will not turn the motor


View more questions Search