 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Handle on kitchen sprayer keeps coming off. How does it go back on?
I have a two handled faucet with side sprayer in my kitchen sink. The poarty of the sparyer handle that you depress to make it spray, keeps falling off. A "handyman" we know has repaired it in the past, but unfortunately I was always at work, and cannot figure out how to reattach it. Obviously no handyman now. It looks as though you could slide it back into place, but don'tseem to be able to do this. There is a post that sticks out from the sprayer, and on the handle there is a "horse shoe shaped part that seems to fit into the area around the pin. Anyone got any ideas?
|
||||
|
||||
|
Hi Kate...
If you have a regular spray hose like below, it sounds like you would be better off replacing the sprayer with a new "universal" sprayer assembly. These are super easy to replace... ;) If you check out the image below you will loosen the spray head from the slide nut and then remove the C CLIP to remove the slider nut and the old spray entirely. Install the new spray by placing the new slide nut in place and then install the new C CLIP in place and install the washer and new spray... should actually be that easy. The hardest part here is getting the C CLIP off... may need to get a little creative here, but the idea is to push both ends of the C CLIP at the same time to push it off the hose stem. Otherwise, this is really a super easy job! Questions? Let me know, OK? Mark PS: The holder nut in the image below is actually up and under your sink holding the holder in place. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a f-g single faucet with pull-out sprayer head. This head either sprays or streams water with the push of a butten. I only streams now. Inside the head is a washer which is bad due to use (20 yrs old). I need to replace and need a diagram to see how to get the 'valve'(?) out and a place to...
I took the faucet apart first because it was leaking at the base of the spout and found an issue with the o-rings, so I replaced those and lubed it with silicone grease. Everything went back to well and the leak stopped, but now there is low pressure coming out of the spout and high pressure coming...
Culprit: Peerless Two Handle Kitchen Faucet w/Sprayer Two part question: 1) Need instructions and photo illustrations (if possible) on fixing a dripping faucet; and 2) same for separate sprayer worked fine just after install but now it does not spray. A slight stream of water is coming from the...
I have a moen removeable single handle sprayer and suddenly the sprayer stopped working. The faucet works fine otherwise except when you press the button to spray it won't spray. I removed the rubber piece for the button sprayer and nothing seems to be broken or missing. Does anyone have any...
Hello, I live in an 18 story apartment building, on the 2nd floor. My kitchen sink seems to be bringing up air. Basically, approximately 2 - 3 times a day, at different times, I will get air coming back up from the drain, which will in turn bring up whatever is in the turn pipe. The air also...
View more questions Search
|
