Ask Experts Questions for FREE Help !
Ask
    bshega's Avatar
    bshega Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 19, 2012, 08:22 AM
    Furnace flame stays on for a couple of minutes
    Furnace flame ignites, blower engages and then the flame goes out. Pilot light stays on and blower stays on for about 10 minutes blowing cold air out. Thermostat was replaced by apartment repairman, still happening. Model: Armstrong 38HWC182-2 S/N: A10749FNA.

    Thanks.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Feb 19, 2012, 06:25 PM
    You should have a flashing fault light on the control board to let you know what is wrong. If this is a rental property you may want to have them come back and take a look at it. If you work on it and its not yours you could be liable for damages.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Propane dryer flame stays on for only 5 minutes then will not reignite after that. [ 0 Answers ]

The area lights up but the flame doesn't come on. After the area lights up I hear a click and then the igniter area goes dark and does this about every 3 minutes but never allows the flame to come back on. The flame is only on at the start for about 2 or 3 minutes.

Furnace runs and turns itself off after a couple of minutes [ 2 Answers ]

Furnace had bad exhaust fan and blower motor fans. Replaced both and furnace runs for about two minutes then the flames shut off the fans run and in about five minutes they reignite and it repeats this process.

Panasonic TV just cuts off and stays off couple minutes then comes back on. [ 1 Answers ]

I have a panasonic TV that's about 5 years old. It will cut off and stay off for a couple of minutes and then come back on. Does it a couple times, then stops. Ive unplugged it, and left it off for couple hours.. and that does not help. I don't think its getting to hot. Any suggestions?

Furnace stays on for 2 minutes [ 2 Answers ]

I have a digital thermostat and my furnace seems to stay on for only 2 minutes at a time. It does this approximately every 10 min. The programmed cycle rate is 5/hr, so starting up every 10 min makes sense. If the programmed temp is 72 F and the room temp is around 72 F, it will start up as...

Buzzing sound stays on for a few minutes when Furnace starts! [ 2 Answers ]

Hi, My gaz furnace is 2 years old and it was running smoothly last year. This year however, it started making a buzzing sound when it starts up. The sound stays for a few minutes and then stops when the heat as been blowing a few seconds. Could anyone give me advice on what this noise...

View more questions Search