 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
If this is a poured lead and oakum joint all you need to do is recaulk the joint. Rent a set of inside and outside caulking irons and recaulk the joint. Don't hit the lead too hard or you'll crack the hub. Just mark it up. If you need help click on back. Good luck, Tom
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I recently purchased a home built (I'm guessing) in the early 1900's. I noticed a leak in my basement coming from the old 4 inch cast iron soil stack running from my second floor bathroom to the basement. There is water dripping down the pipe to the basement. Three plumbers have come out to...
Hi I was wondering I have a 4 in cast iron that has a hole in it and I need to replace with pvc what would I do to replace I know some what about plumbing I just don't know anything about cast iron
4 inch cast iron main drain has a slow leak at what I think are small cracks in the line at the Y of the clean out just before it goes into the slab of the basement floor. It is old stuff, the house was built around 1902. What are my options in fixing this. Thanks in advance.
Hi there guys, I'm helping some friends this coming weekend in their kitchen. We'll be pulling their sink, building some cabinets, replacing the countertop then reinstalling the sink. During the week, they've been stripping some old paint/sealer off the sink with a heat gun. You know the...
Following the sage advice found on this site in other postings, I managed to remove the misshapen, rusted waste pipe that went from my downstairs toilet to the horizontal main line (cast iron). So now I have a cleaned out bell and test fitted a neoprene donut from Lowe's (4" to 3") and plan on...
View more questions Search
|
