 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a concord 80.
I have a concord 80.
The blower kicks on then the burners kick in and run for about 3 to five min. Then the burner shut off. But the blower will keep running, And the burner will not kick back on. I have taken off the front plate cove of the furnace. To get accesses to the burner and then we do not have a problem. With the plate off it gets more air and it will burn better? What is the problem and what can we do about it? |
||||
Check out some similar questions!
I have a concord 80 plus that is mounted horizontally. The pilot light turns on, the gas ignites, but will only stay lit for a few seconds. It will try this three or four times before the blower shuts off. The thermostat works fine (atleast it did for ac). Any suggestions?
This is a one year old unit. It had a freon leak on the high side connection next to the compressor. The leak is sealed, but after vacuum and charge, the solid state board shows a continuous green light with nothing on the red light next to it. Please tell me what this light code is.
Why dose my furnace go out at night by its self and not try to start it seams like it could be a roll switch if I take the cover off then push the black switch in it works fine for a while again and then dose it again with in a day what could it be??
The furnace is about 4 years old was working great yesterday now it won't heat the ac works the fan on manual works the heater dose nothing is there anything I can do without calling in expensive repair people
h, I wants to know that my cars heating works but airconditiond doesn't works so what should I do to solve this,
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
