Check out some similar questions!
Well motor -Short Cycling
[ 13 Answers ]
Old houses... great aren't they? I have a new dilema. Seems as though the well motor is beginning to short cycle during a shower or if the washer is running. I would suspect the pressure switch, however I do not know which side is the low side and which is the high side, nor do I know where to...
Tempstar T9MPV gas furnace blower short cycling
[ 0 Answers ]
We have a brand new Tempstar T9MPV gas furnace and Heat Recovery Ventilator, which both have separate but somehow linked Thermostats. Our furnace blower cycles between High and Low for less than 30 seconds at a time and the burner stays on for about the same time. Filters are kept clean. What...
Short cycling
[ 1 Answers ]
Rapid on,off cycling at low pressure cut in,does not close circuit to pump
Why is my well short cycling?
[ 11 Answers ]
I've got a new pump, new control box, new pressure tank(with bladder), new pressure switch, but... I can't get my well to stop short cycling, I've checked and my bladder psi is 38 and pressure switch is set for 40-60; sometimes it will cycle when closing in (40psi) click, click, click until I open...
Short cycling furnace
[ 0 Answers ]
Hello Again, Thank you for the previous help suggestions. The last suggestion I received mentioned the possibility of a defective limit switch. I replaced the switch but that did not solve the problem. However, I did received a fault LED, "defect or flaw in gas flow". I checked my line,... View more questions Search
Add your answer here.
|