Armstrong 95% furnace installed 2002

mikemarcum Posts: 1, Reputation: 1

New Member

Jan 15, 2012, 09:05 AM

Armstrong 95% furnace installed 2002

Furnace seems like it is not pulling cold air back through cold air returns ,replaced air bear filter about 4 months ago still relatively clean also seems like second stage is not kicking in.

Check out some similar questions!

Armstrong ultra sx-80 furnace [ 1 Answers ]

I have an ultra sx-80 furnace it seems to work fine until it reaches set temp finally it kicks off and acts like it wants to keep trying to come back on every few seconds it will keep doing this until temp falls under set level then kicks back on and works fine until hits set level again then it...

Armstrong furnace troubleshooting? [ 3 Answers ]

I have an Armstrong Model UHPA090AE1 hanging unit in garage. The unit has a spark ignition and the unit fire the flame last for 25-30 seconds than goes out and re ignites. I checked the High limit its good and the flame sensor looks brand new and was replaced last year. I did clean the flame sensor...

Armstrong Ultra SX 80 furnace won't stay on [ 16 Answers ]

We have a Armstrong Ultra Sx80 furnace, model GUJ050D10-3A, with a HeatCraft Control Board, cat number 70k98 (40403001). Everything fires up fine… thermostat, inducer motor/fan starts, then ignitor, gas, and the burners light, etc. After the burners are lit for 30 seconds, the blower starts to...

Armstrong furnace sx80 [ 1 Answers ]

The small circulator fan on the front of my furnace will not shut off

Armstrong furnace won't cycle [ 1 Answers ]

Maybe you could help me? I cannot ask a question on the forum and I cannot get it to let me register as well. I have a 10yr old Armstrong Ultra SX 80 furnace. The furnace will receive a call for heat from the termostat it will cycle correctly ( induced draft motor, pilot will lite, gas...

View more questions Search

Check out some similar questions!

Add your answer here.