 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Central heating stops working when the temperature has been reached...
Central heating stop working when reach temperature that we set(66*),fan continues working not heat for long time and does not want to turn off,either manual from the thermostat. We have to turn off from the electrica panel.thermostat and intermitten pilot ignition control has been replaced still same problem.(note:sometimes work perfect)
|
||||
Check out some similar questions!
It is a Glowworm Betacom 30C, about 15 months old. The Pressure warning led is flashing and the pressure gauge reads about 0.3bar. Last night I bled some air from a radiator and assume that is the cause, although it was never a problem with the old system.
Hi. My Central AC stops cooling in High Heat. The tech came and said that it is a Utility issue since the voltage coming into the unit was only 195 V and the unit needs 230 V to run. What should I do? Thanks. Matt
Fan on my York Stellar Plus Gas-fired central air unit stays on for about an hour after thermostat reaches temp and shuts off combustion. It just blows room temp air after heating to desired temp. Seems like a waste of electricity. Unit is about 10 years old and seems to otherwise work fine. Any...
My central heating blower is not working. Fan on outside unit works but inside fan does not. When I manually turn the fan on at the thermostat it still does not work. What do I need to check? Mine is electric furnace. The weather is getting cold lately but I could not turn my heater up... so sad......
Hello, I have an old house and the gas furnace is just about as old as the house. The problem I have is that the temperature on the first floor is a lot higher than the basement. I did try to close some of the vents on the 1st floor and open the ones in the basement but I still have a big...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
