Ask Experts Questions for FREE Help !
Ask
    spartan56's Avatar
    spartan56 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 12, 2012, 06:23 PM
    TRANE TDC080C942A1 main limit switch what part number
    I do not know the part nu. For the main limit
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Jan 13, 2012, 05:32 AM
    It should be written on the part,, take it with you to the parts house

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Where is the limit switch on a trane XL90? [ 2 Answers ]

Had a Trane XL90 two-stage high efficiency gas furnace installed in 02'. Open limit switch diagnostic L.E.D. came on last night and the electrical schematic is completely corroded need help finding the switches. Thermostat said 43 this morning.

Trane Limit Switch [ 3 Answers ]

I have a Trane Gas Furnace, model # TUE120A96OK3, that is 6 years old. I am having an issue with it where the burners will not stay lit. I check the red LED light diagnosis, and it says that it is having an "open high limit device" error. I thought that I could possibly reset or replace this to fix...

Where is the high limit switch located on a Trane XR80 furnace [ 1 Answers ]

I was told by a Trane technician that either my high limit switch or the fan relay was causing my problems. The relay is on the control board, but where is the high limit switch

Where is the high limit switch located on a Trane XR80 furnace [ 1 Answers ]

My furnace kicks the burner off when the fan starts. After 30 seconds the burner comes back on and then it runs through its cycle pretty much like it's supposed to. I was told by a Trane technician that it could either be the control panel orthe high limit switch. Where is the high limit switch...

Trane xe 80 open high temperature limit switch [ 1 Answers ]

Furnace is about 13 years old... we just replaced the ignighter in it last night because it was running through all the steps to run except ignighting. It fired right up and ran for about 7-8 hours... now it won't ignite at all (it is running through all the steps it needs to except for...


View more questions Search