 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Tempstar T9MPV gas furnace blower short cycling
We have a brand new Tempstar T9MPV gas furnace and Heat Recovery Ventilator, which both have separate but somehow linked Thermostats. Our furnace blower cycles between High and Low for less than 30 seconds at a time and the burner stays on for about the same time. Filters are kept clean. What could be causing this cycling?
|
||||
Check out some similar questions!
My old exhaust blower is very noisy at times. I have a new placement to install. Seems pretty straight forward. Any tips? Is the condenser uncharged when I remove the old oneif main power is shut off?
This summer I had my air conditioning unit replaced after the previous one unknowingly froze up and as a result blew up. The new unit was working well after it was installed in conjunction with the natural gas furnace without issue - albeit the blower on the furnace unit distributes the cold air...
I have a Comfortmaker RPJ II (Enviro plus 90) gas furnace connected to a programmable thermostat that works and cycles on and off fine when inside temp is lower than set target temp - exhaust blower cuts on, pressure switch engages, igniter glows, valve opens, pilot lights, valve opens, jets...
I have an older Sears "Fifteen" horizontal gas furnace (#867767840) located in the crawl space. Recently it has been short cycling, meaning it starts a normal cycle, runs for approximately 1 minute, stops for several minutes, then starts another 1 minute cycle. This repeats until the set...
I have a Trane XL80 (Model #TUD060A936A0) that has been converted to a White-Rodgers (Model #50E47-060). When the thermostat calls for heat, the furnace short cycles until it is manually shut off. There is no indicator light on this unit to tell me what the problem may be. What else could...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
