 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
Heating and air unit
A few days ago the heat would not kick on so we turned it off and on at the thermostat a few times and it finally kicked on and worked fine for about a day. Then the same thing happened again. We then did the same thing by turning the thermostat up and down until it finally kicked on. The next day...
I tried to install a relay to bring on my blower motor which is a good motor. However I have 24 volts that energizes the relay therefore closing the high voltage circuit going to the blower. The common leg is still going to the breaker and the speed tap is hooked to my relay. However the blower...
Nordyne model E1EB-015HA How do I check the sequencer's and limit switches what are the omh's values or what should be open or closed on the bench, I have the furance and coils on the bench for testing. Unit blows transformer in service. Was great before I cleaned the cooling coils above the...
Hello I have an nordyne e23h012hn electric furnace, the control board is burnt and evaporator fan will not come on, replaced board and it burnt up to. The circuit on the board that burnt is the common line voltage to the fan, could it be the fan motor shorted causing this problem . Thanks chris ...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
