Ask Experts Questions for FREE Help !
Ask
    Petrofam's Avatar
    Petrofam Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 3, 2012, 04:16 PM
    Bryant 90i no blower
    Gas lights but blower don't kick on. Error code 15. Help were cold
    Petrofam's Avatar
    Petrofam Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Jan 3, 2012, 04:25 PM
    By the way it's a 355mav I get I short yellow light followed by 5 long yellow lights. I found a large piece of a black filter that appears to have been glued to the back wall behind the blower torn off and laying in the blower.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant plus 90i gives code 42 [ 1 Answers ]

I have ran the test and it said that the inducer was fine but to check the hot surface lighter. The lighter fires in test but not when u call for heat.

Bryant plus 90i code 42? [ 0 Answers ]

My Bryant plus 90i furnace won't run. The inducer motor is not ramping up to speed. Put in new inducer, new main circuit board, but the problem persists. My furnace guy is stumped. Anyone have any idea?

1995 Bryant 90i Plus won't ignite [ 3 Answers ]

Hi, My furnace starts fan, pressure switches activate, gas valve turns on, but ceramic ignitor is not glowing. I changed the ignitor and no improvement. I measured the voltage on the plug with the ignitor disconnect during startup and only got 8 volts AC. Does this indicate that the control...

Bryant plus 90i code 34 [ 9 Answers ]

Bryant plus 90i. A 355 mav I believe. Will not ignite. I get code 34 then code 14. I have read the codes and have tried cleaning the flame sensor, blowing out all the condenser tubes and the green wire ground wire is connected to the chasis. I have taken the flame box cover off and it still didn't...

Bryant furnace plus 90i problem [ 1 Answers ]

Bryant furnace "Plus 90i" will run, flash red light a couple of times, shut down, then gear up and run again. It can do this 4-6 times over the course of several hours while heating the house up to 68 or 70 degrees from an overnight temp of 61 degrees. The service techs have checked the...

View more questions Search