Ask Experts Questions for FREE Help !
Ask
    chief05.steve's Avatar
    chief05.steve Posts: 3, Reputation: 2
    New Member
    		  
    #1

    Dec 30, 2011, 12:06 PM
    92 Honda won't start. No pulse going to injectors.
    I have a 92 Honda Civic that won't start. I checked fuel pressure and it was good, I also checked if spark plugs were getting fire and they are. The motor cranks but does not start, also checked pulse to injectors and I am not getting pulse to injectors. Should I change distributor?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Dec 30, 2011, 02:58 PM
    If the CEL comes on for 2 seconds and then goes out, when the ignition switch is turned to ON (Position II), then replacing the ICM and coil usually solves the problem. If the problem persists, install the new ICM and coil in a new genuine Honda distributor housing--all others are suspect. Apply silicone heat transfer grease to the back of the new ICM. If you want, install a new genuine Honda distributor.
    chief05.steve's Avatar
    chief05.steve Posts: 3, Reputation: 2
    New Member
    		  
    #3

    Dec 31, 2011, 01:03 PM
    My 92 Honda Civic still will not start, I replaced distributer and I am still not getting injector pulse, also checked that CEL and it stays on costantly (does not go out after 2 seconds). I am really lost now.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #4

    Dec 31, 2011, 01:06 PM
    . Test all under hood and under dash fuses with a test light or multimeter. Be very thorough. Especially test the ACG (ALT) (S) fuse in the under dash fuse box.

    . Perform the K-Test on the ECM.

    I suspect the ECM is toast.
    chief05.steve's Avatar
    chief05.steve Posts: 3, Reputation: 2
    New Member
    		  
    #5

    Jan 10, 2012, 07:01 AM
    Replaced ECM and it started right up, Thanks TxGreaseMonkey you know your stuff!!
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #6

    Jan 10, 2012, 07:05 AM
    Nice job, chief.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Injectors in a 1996 honda civic lx are not working... why? [ 0 Answers ]

Not pulsing gas

How can I check my fuel injectors 97 Honda Civic [ 2 Answers ]

I'm getting 2 OBD codes which are PO302 and PO304 What can I do.

90 Celica GT-S, won't start, turns over, cold start works, 12V at injectors [ 2 Answers ]

Replaced ECM, does same thing, 12V at injectors but when you turn it over they don't open, have fuel and spark, checked ground for injector harness, have factory manual, checked many sensors with no luck. Cold start works and it fires briefly until the fuel from that is spent. Does not show any...

95 honda civic no injector pulse [ 1 Answers ]

I have a 95 honda civic that will not start. I had my neighbor try to put his scan tool on it to get the engine codes out but there was no connection to it. He told me that there is a goot chance that the computer is bad. We changed the fuel pump-main relay and distributor. As far as I can see that...

93 civic cx will not start . Injectors has no pulse/ no fuel pump [ 1 Answers ]

93 civic cx np pulse to injectors and pump (fuel) WILL NOT COME ON WHEN IGNITION ON. REPLCED DIST. FUEL PUMP , MAIN RELAY STILL NOTHING

View more questions Search