Carrier WeatherMaker 9200 flame sensor

baroo13 Posts: 1, Reputation: 1

New Member

Dec 31, 2011, 10:50 AM

Carrier WeatherMaker 9200 flame sensor

I need to clean the flame sensor on my Carrier WeatherMaker 9200 but it seems pretty tough to get to. Is there a semi-easy way to get to it without taking the whole thing apart?

Check out some similar questions!

Carrier 9200 weathermaker gurgling sound [ 1 Answers ]

Carrier WeatherMaker 9200 turning on and off after increasing by 1 degree [ 0 Answers ]

I have a Carrier WeatherMaker 9200 Ultra High Efficiency Gas Furnace Model 58MXA080-16. The temperature in the house has dropped down to 65 degrees and the furnace will not come on. I was able to get it to come on once last night and once today and the temperature only went up one degree (66). I...

Where do hoses go to from pressure switch on carrier weathermaker 9200 [ 1 Answers ]

Hose off bottom side of switch and don't know where it goes

Carrier 9200 Weathermaker gas furnace -- no heat [ 4 Answers ]

The furnace is about 5-6 years old, and advertised as "ultra-efficient". Gas furnace is inside, Carrier Tech 2000SS A/C is outside. Heat won't come on, despite my reset efforts: -turn thermostat to lowest setting -turn off all electrical power to furnace -remove access panel from furnace...

Carrier 9200 weathermaker [ 1 Answers ]

Have a carrier 9200 weathermaker... when I turn up the thermostat for the heat to come on the small fan starts then the heating element glows... then heating element goes back off... and it shuts back down... I get 3 - 4 code...

View more questions Search

Check out some similar questions!

Add your answer here.