Ask Experts Questions for FREE Help !
Ask
    misterdubs's Avatar
    misterdubs Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 24, 2007, 01:21 PM
    Kenmore Washer Spins/Rinses but Will Not Fill or Cycle
    (Series 70) The washer worked fine until I had to replace the coupler between the motor and transmission. When I put everything back together and plugged it in it tripped the breaker. I had not properly replaced the wiring harness at the rear/top of the cabinet. After taking care of that, I plugged it in, turned it to a spin cycle, and was pleased to see that I had fixed the initial problem. I turned it to the beginning of a wash cycle and nothing happened. Water didn't fill. I blew into the pressure valve and could hear it clicking. The hose seems fine. Water does run during the rinse cycle (which times out properly) but will not fill on any other setting. Furthermore, when I turn the control knob, the washer will enter spin mode whenever the knob gets to spin mode even though the knob is pushed IN. I'm assuming the timer was somehow damaged during the earlier repair, but I'm hoping there is another possibility. That's where you come in!
    stew_1962's Avatar
    stew_1962 Posts: 255, Reputation: 10
    Full Member
    		  
    #2

    Mar 3, 2007, 07:50 PM
    Sounds like the timer to me... :(

    Stew
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore washer noisy spin cycle [ 1 Answers ]

I have a Kenmore washer purchased Mar. 2001. The final spin cycle is very noisy (sounds like -but isn't- an unbalanced load) what should I check first?

Kenmore Washer Won't Fill on Rinse Cycle [ 2 Answers ]

Everything else is working fine, it fills normal on wash, but not rinse, no matter what cycle such as perm press, ultraclean.

Kenmore 70 washer water fill leak. [ 2 Answers ]

I have a Kenmore 70 series washing machine (older model) that drips water from the same area that is used to fill the washing machine tub. Any suggestions on repairs?

Kenmore Washer Won't Complete Spin Cycle [ 0 Answers ]

Hi, I have a Kenmore 110.4549290 that will agitate, and even will spin up to and including the start of the rinse cycle. It then drains the first rinse water, puts in a couple cups of water, but does not go into the rest of the spin cycle. The timer can be heard running (quietly), and it shuts...

Kenmore washer continues to fill [ 1 Answers ]

Hello. I have a Kenmore Elite Catalyst, model# 110.20052994. About a week ago, it would not drain. I even tried pressing the drain button on the control panel, but it did not work. So, I drained the water by hand and tried to run through another small load cycle. Now, the washer continues to...

View more questions Search