 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Gas burners not getting gas, pilot light gets gas & comes on
Day & Night Heating furnace:
The electronic ignition turns on the gas pilot with flame. Pilot light gets gas from the gas valve unit but main Gas-valves do not open up and the gas-burners does not light up with flame on the pilot light? Any inputs with would be of great help. Thanks! |
||||
|
||||
|
You may need a new flame sensing device (may be separate, or may use the sparker as a flame senser) or the ignition module may be fualty. I would start by trying to clean the flame senser. If the flame senser does not sense the pilot flame, it will not allow the main burner to ignite.
|
||||
|
||||
|
I noticed that the due to the heat the crimp-lug on the wire that connects to the terminal point of the Pilot-sensor was not making good contact. Now I need to replace the crimp-lug with a new high-temp crimp-lug to make contact with the Pilot-sensor terminal point. I need to find the crimp-lug, had no luck today (12-26-11) as couple of the appliance parts stores are closed today in Orange County. After I fix that then I hope it resolves my problem.
If not, then it could be the 1) pilot sensor itself is bad or 2) the main Gas Control-valve unit or the Controller is bad... I will have to see after I fix the crimp-lug connection to the Pilot sensor |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My carrier gas furnace would not light up the pilot burner although sparks and gas is present. I've tried to light up the pilot burner with a gas grill light and it works.
Rheem model rgda 075a cr.replaced thermostat cleaned heat sensor.. no change.. next step was replacing heat sensor but unsure were and what sensor to buy."ANP001FS Universal Flame Sensor Electrode" appears to be a match(visually) to the one it cureently has.. but that is online.. any advice would...
All right, I'm at my wit's end and I could use some help... Last week my furnace started blowing cold air. The pilot lights fine, but the burners will not light. My ex-wife's boyfriend's friend came out and looked at it and suggested we replace the furnace, said the heat exchanger/combustion...
Gas furnace doesn't come on the fan for fresh air/exhaust and pilot light comes on but gas valve not letting gas in to burner so it doesn't light,but if I turn off power and back on three or four times it will work until house cools and need heat again
I have a gas fireplace and on a windy day the pilot light actually went out. My dad said that even though the pilot light isn't on it's emitting gas into the house- which is a health hazard, but I thought that as long as the switch that turns on the light is off there is no risk. Can anyone tell me...
View more questions Search
|
