Ask Experts Questions for FREE Help !
Ask
    thenancys's Avatar
    thenancys Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 24, 2011, 12:45 PM
    Furnace won't relay signal from thermostat
    Furnace will not go on. It receives the signal from the thermostat but doesn't relay the signal. The light flashes once (which means check furnace). (The Fan works when you turn it from auto to on) Now what? Could it be the circuit board? How do you check? Merry Christmas! Help!
    majdir's Avatar
    majdir Posts: 7, Reputation: 1
    New Member
    		  
    #2

    Dec 25, 2011, 01:44 PM
    I would check the start/Stop settings on the furnace, may be the start setting is set too low. Or it could be that the thermostat is mounted close to a light bulb, so the thermostat is transmitting a high temperature reading to the controller.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #3

    Dec 25, 2011, 04:26 PM
    What happens if you jump r to w at the furnace? If heat sequence starts, then you either need a new stat or stat wire.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring a thermostat to relay [ 0 Answers ]

How do you wire a thermostat pro 1000 to a r8239d relay to a pump for in floor heating?

Relay after thermostat before condenser [ 1 Answers ]

How do I find out which rlay is blown?

Thermostat relay [ 2 Answers ]

Hi I've been having a/c problems for thelast 3 months in my apartment where the a/c won't cut off when I change the thermostat into the off position. I also notice that it won't cut off when in the auto position as well. To get it to cut off I have to play with the switch from off to heat to off to...

Thermostat and relay ? [ 2 Answers ]

I have 2 wire thermostat controlling a window ac using 220 v . I replaces the burnt out 24v transformer . The AC worked but when I turned of the thermostat and then turned it back on the new transformer heated up and stopped working again . I replaced it again and the new one also burnt out . (3...

Thermostat Compressor relay [ 1 Answers ]

An AC technician serviced my unit today and told me my compressor was cycling (turning on and off) too quickly. He suggested I change out my thermostat, which I did last January. I installed a Honeywell RTH 230B. I can't find any info as to whether it has a compressor relay or anything else that...

View more questions Search